Skip to content
DestinationSideways

From Bend, Oregon.

We make one part: a bearing that sits between a coilover spring and its lower perch. When the strut turns, the perch turns on the bearing instead of twisting the spring.

The first version came out in 2021, and a few sets from that run are still on hand. V2 is in the works. It'll be here when it's ready.

V1 adapter installed on a car, between the bottom of a blue spring and the green lower perch of the coilover.
  • Blue V1 60 mm Radial Adapters, engraved Destination Sideways, stacked on a glass counter.
  • Two BC Racing coilovers on a workbench with blue V1 adapters fitted under the bottom of the springs.
  • V1 adapter parts laid out on a counter: blue and silver housing halves, two needle bearings, thrust washers and o-rings, with the original box and two bottles of lubricant behind them.
  • Close view of a V1 adapter installed between a black spring and the red lower perch of a coilover.

From the bench to the car.

V1 took 37 versions. We designed, printed and tested different housings, worked through the fit on the bench, and installed the adapters on the car.

V1 development
A pale blue housing on the bed of a desktop 3D printer.
A pale blue housing on the bed of a desktop 3D printer.
Pale blue and black housing shapes side by side on a bench.
Pale blue and black housing shapes side by side on a bench.
Two coilovers with blue adapters beneath their grey springs on a workbench.
Two coilovers with blue adapters beneath their grey springs on a workbench.
A coilover installed inside a wheel well, with a blue V1 adapter between a yellow spring and purple lower perch.
A coilover installed inside a wheel well, with a blue V1 adapter between a yellow spring and purple lower perch.

Say hello.

Got a fitment question, or a build to show us? Email is the quickest way to reach us.

Email usFitment

    We use cookies to run the shop and analytics to improve it. Analytics is on by default, and you can opt out anytime. See our Cookie Policy.